AFR Software

AFR Calculation Software


This software is only required when using the optional AFR sensors in conjunction with the DataLogger.

 Your original bin file is loaded and the TPS / RPM map points are taken together with the original fuel map values.

 The software then loads single or multiple log data files and processes them to show AFR values for every cell captured over the entire range of the fuel maps. Several configuration options are available to merge files, filter any deceleration or very fast 1st gear acceleration etc

 The actual AFR values are compared with the target AFR values and the fuel maps adjusted accordingly. You can set the AFR tolerance for adjustment and the amount of correction applied. Manual adjustment is available using the AFR Graphs tab.

 The modified fuel maps are then saved to a new bin file ready for testing. 

 Below are screen shots of some of the main pages of the software.















Popular posts from this blog

Bluetooth Data Logger

Image
Now with Android Data View App USB Upgradeable 4GB Micro SD Card New Bluetooth Android version - Thanks to Manuel Stahl for his help with the Android software. The high speed data logger is a small aluminium enclosed plug and play module that records and displays sensor data both from the ECU and up to four additional 5v analog inputs such as AFR sensors. These inputs are are calibrated to +-0.1% so the 5v signals will always give accurate results. It can also display and clear validated faults and run all of the standard actuator tests.  Power is taken from the battery tender connector and the input cable is connected directly to the ECU diagnostic plug.  It is firmware upgradable for any future additions or enhancements. The main purpose of design was to  simultaneously  record road AFR and ECU data, then through my AFR software and the appropriate hardware enable tuning of the fuel maps within the ECU.    All sensor values can b...
Read more

Data Logger

Image
The high speed data logger is a small aluminium enclosed plug and play module that records and displays sensor data both from the ECU and up to four additional 5v analog inputs such as AFR sensors. These inputs are are calibrated to +-0.1% so the 5v signals will always give accurate results. It can also display and clear validated faults and run all of the standard actuator tests.  Power is taken from the battery tender connector and the input cable is connected directly to the ECU diagnostic plug.  It is firmware upgradable for any future additions or enhancements. The main purpose of design was to  simultaneously  record road AFR and ECU data, then through my AFR software and the appropriate hardware enable tuning of the fuel maps within the ECU.    Up to 3 sensor values can be displayed on the 2 line display at once. When using a wideband sensor controller such as the Innovate LC-2 with maximum analog output rate of ...
Read more